![]() If all else fails, factory reset your lock. monitor security and privacy settings, find the device when it's lost, lock and remote wipe it, and maintain automatic updates.Restart your modem or router, unplug it from the power outlet, wait for 1 to 2 minutes.The recommended router settings are the 2.4 GHz Wi-Fi frequency. Open the Settings menu on the thermostat and select Factory Reset. ![]() Keep holding down the button, when the light flashes yellow then goes off, release the button. Here are the steps to follow to factory reset a Nest Thermostat. Hold your Connect’s button for much longer than 8 seconds, the light will turn yellow, which means your Connect is preparing to factory reset. On the command line you will switch to the drive letter of your NEST device (for me it was F:). Hold down Connect’s button until the light pulses blue (about 10 seconds). You will then open up the Command Prompt in Windows (windows key + r to open the run box and then type cmd.) 6.Wait a few minutes to check if your lock comes back online. Put the batteries back in after 60 seconds.Don't use rechargeable batteries with your lock. Open the Yale Access App and go to the lock circle screen, which is the screen that shows you whether your door is locked or unlocked. If you received a low battery alert, use a fresh set of standard AA batteries. Take off the battery cover and remove the batteries from your lock.Here are some troubleshooting steps you can try: it will be online and work and then go offline. We have a nest connect bridge connector set up close by. No worries, we’ll check this out - a few questions: what’s the status light of your Nest Connect? How far is your Nest x Yale Lock and Connect from the router? Are the batteries of your lock fresh and standard AA alkaline batteries? Also, what Wi-Fi frequency band do you try to connect to (2.4 GHz or 5 GHz)? 07-31-2022 05:37 PM Nest Yale lock keeps going off-line. A yellow light means that Connect is trying to reset itself to factory defaults, which will remove Connect from the app. Then immediately press and release the button once. Connect is online with a good signal, lock still can not find it. Tip: If you hold Connect’s button for more than 8 seconds, the light will turn yellow and that means you should release the button right away. I’m sorry to hear that and for the delayed response here. I have factory reset my lock and my nest connect.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |